![]() Wiimotes don't work so I try and sync them, but I think this made them LOSE their sync. Then the Wii would go from the red light and power up, flashing blue light of the disk tray, disk spinning, light turns green, all good, NO DICE I got the black screen of DOOM. I threw it away, bought a transformer, and plugged my original adapter in. TWIST it's a knock-off european adapter to allow my USA Wii to run on exotic european voltages. Wii stayed at red light no matter what, some googling told me it was the power adapter. ( Not sure if this information is relevant, this is the first time I did this stuff, maybe I did it badly? But I am normally pretty good at following directions. Then the power breaker popped while I was playing a scrubbed and converted to wbfs backup of my Mario Galaxy 2 disk from a fat32 drive. I have a launch Wii, so I was able to install BootMii on Boot2 and made a NAND backup and installed priiloader and all that good stuff. I think I have finally reached the limits of my google-fu and it is probably better to start a new thread rather than to glean bits and pieces of information from guides that may or may not apply to my situation.Ī couple days ago I heard it was possible to softmod my Wii, so I found Maui's genius guide here (much thanks to him!) and I followed it. I hate to do this, for I am a champion lurker, but I have to create a new thread. Having a copy of SSBB, could I program a DriveKey to autoboot the retail disc and use that to perform a Smash Stack, enabling me to get into BootMii? I also have a second Wii I could use to program a DriveKey to perform autobooting. A serial check tells me my drive CAN do backups, but I did not have DARKCORP installed, so it currently can't do it. ![]() ![]() ![]() If it comes down to opening the Wii up, I'm wondering if most prudent course of action would be to get a DriveKey (moderately priced with relatively low installation difficulty-I've had to transplant 1.8" HDD with the same types of ribbon cables, so I'm familiar with how they work). Am I correct in assuming that this is one that will have to have some hardware work done (NAND reflash, drivechip installed, et al) or do I still have nondestructive options? PS. However, at this stage it seems I don't have the capacity to reach BootMii, the HBC, WAD Manager, or any other means to take the offending WAD off. My only saving grace is that before all this havoc began, I DID use BootMii IOS to back up the NAND. I have attempted to use SaveMiiFrii using a burned recovery disc (I'm pretty confident I installed some sort of backup-enabling system), but this is probably a model where burned discs cannot be read, and there don't appear to be any places to get the discs pressed. Thought I had Priiloader installed, but it either failed to install or it got overlooked, and it is not a model that can do BootMii via boot2. A banner brick caused by a buggy WiiGSC WAD. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |